Woodworking And Sanding Go Together
Sanding is one of those things that is low on the priority list but high on the necessity list. Very few of us want to do it, but we all know that we have to do it. And, even though most of us aren’t excited about it, the quality of a sanding job can be the difference between a masterpiece and a large paperweight. Poor sanding techniques cannot only ruin the actual piece but can also ruin the finish. No single tool in the shop can be so disastrous (note that I didn’t say bloody).
It all starts with the right mindset. Often sanding is viewed as an obstacle, something that gets in the way of actually finishing, but it is the opposite. Sanding is finishing. Treat is as a separate and integral first part of the finishing process.
Be happy about it. If you break a woodworking project into two halves, the second half would be the finishing, which starts with sanding. Celebrate that your project is more than halfway finished and sand with a smile on your face. If you aren’t happy about it, at least try to fake it.
Don’t be lazy. Laziness shows up in the worst ways. Hard to reach areas will still have saw marks. Wide open areas will have chatter marks from the planer. Glue joints won’t be flush. If you don’t want to put in the time to sand, don’t be a woodworker! (Wow! That was harsh.)
Be disciplined. Don’t sand just because you are supposed to. Sand with a purpose, achieve the goal, and stop. Lack of discipline only creates more problems. Sanding through veneer, sanding through topcoats or stain, sanding across the grain, and rounding off edges too much (and this is only a partial list) all come from a lack of discipline.
Obviously, I think sanding (good sanding) is critical. Think about the four points above next time you are sanding and see where you land. It may be the difference between woodworking success or failure.